A
UTHENTICATION
C
OMMANDS
4-105
dot1x max-req
This command sets the maximum number of times the switch port will
retransmit an EAP request/identity packet to the client before it times out
the authentication session. Use the
no
form to restore the default.
Syntax
dot1x max-req
count
no dot1x max-req
count –
The maximum number of requests (Range: 1-10)
Default
2
Command Mode
Interface Configuration
Example
dot1x port-control
This command sets the dot1x mode on a port interface. Use the
no
form
to restore the default.
Syntax
dot1x port-control
{
auto
|
force-authorized
|
force-unauthorized
}
no dot1x port-control
•
auto
– Requires a dot1x-aware connected client to be authorized by
the RADIUS server. Clients that are not dot1x-aware will be denied
access.
•
force-authorized
– Configures the port to grant access to all
clients, eitherdot1x-aware or otherwise.
•
force-unauthorized
–
Configures the port to deny access to all
clients, either dot1x-aware or otherwise.
Console(config)#interface eth 1/2
Console(config-if)#dot1x max-req 2
Console(config-if)#
Summary of Contents for TigerSwitch 1000
