![background image](http://html1.mh-extra.com/html/smc-networks/tigerswitch-1000/tigerswitch-1000_management-manual_1300422106.webp)
C
ONFIGURING
THE
S
WITCH
3-58
To add new VLAN members at a later time, you can manually add secure
addresses with the Static Address Table (page 3-108), or turn off port
security to reenable the learning function long enough for new VLAN
members to be registered. Learning may then be disabled again, if desired,
for security.
Command Usage
•
A secure port has the following restrictions:
- Cannot use port monitoring.
- Cannot be a multi-VLAN port.
- It cannot be used as a member of a static or dynamic trunk.
- It should not be connected to a network interconnection device.
•
If a port is disabled (shut down) due to a security violation, it must be
manually re-enabled from the Port/Port Configuration page
(page 3-80).
Command Attributes
•
Port
– Port number.
•
Name
– Descriptive text (page 4-132).
•
Action
– Indicates the action to be taken when a port security violation
is detected:
-
None
: No action should be taken. (This is the default.)
-
Trap
: Send an SNMP trap message.
-
Shutdown
: Disable the port.
-
Trap and Shutdown
: Send an SNMP trap message and disable the
port.
•
Security Status
– Enables or disables port security on the port.
(Default: Disabled)
•
Max MAC Count
– The maximum number of MAC addresses that
can be learned on a port. (Range: 0 - 1024, where 0 means disabled)
•
Trunk
– Trunk number if port is a member (page 3-83 and 3-85).
Summary of Contents for TigerSwitch 1000
