1 - Windscreen
❑ Remove windscreen
.
❑ Install windscreen
.
2 - PUR - glue sealing material
❑ Adhesive bead cross-
section -width b- = 6 - 8
mm, - height a - = 10 - 12
mm (including the seal‐
ing section, residual
sealant on window and
window flange).
❑ Minimum hardening
time
.
3 - Body flange
4 - Gap size
❑ From the lateral window
edge up to the A pillar.
❑ Set the constant dimen‐
sion of 2.5 ± 0.5 mm with
the setting gauge -
3371- .
5 - Gap size
❑ From the top window
edge up to the roof
edge.
❑ Set the constant dimen‐
sion of 2.5 ± 0.5 mm with
the setting gauge -
3371- .
6 - Window pane adjuster
❑ Remove the window pane adjuster at the earliest 120 minutes after installing the window pane.
7 - Fitting section
❑ Is part of the windscreen.
8 - Plenum chamber cover
❑ It must only be pulled from the fitting section by hand.
❑ Remove the plenum chamber cover
⇒ “1.8 Plenum chamber cover”, page 13
❑ Install plenum chamber cover
1.4
Removing windscreen
– Remove A-pillar trim panel
⇒ “3.1 Removing and installing top trim panel of pillar A”, page
.
– Remove all sun visors
⇒ “2.6 Removing and installing the sun visor”, page 208
.
– Removing interior rear-view mirror
⇒ “1.2 Removing and installing the interior rear-view mirror”,
Rapid NH 2014 ➤ , Rapid Spaceback 2014 ➤
Body Work - Edition 10.2018
144
Rep. gr.64 - Glazing