4-31
1
2
3
4-6 LINEAR ENCODER SETUP
Lower Pinch Rollers.
Make sure to unload the media when it is set on the
machine.
Then, turn on SUB POWER SW while pressing [ ], [ ] and
[ ] keys to enter SERVICE MODE.
Select [PRINT MENU] > [LINEAR ENCODER] in SERVICE
MENU and press [ENTER] key.
One of the messages will appear at the completion of the
set up.
In case of SETUP error, check the followings.
1. Dirt/Scratch on Encoder Scale.
2. Dirt/Scratch on Encoder Module.
3. Encoder Scale is not between Encoder Module.
4. Backlash of Carriage Motor Gear and Drive Gear.
5. Bad Contact in the cables.
In case of HEADBOARD error, Head Board could be
defective.
PRINT MENU
LINEAR ENCODER
NOW PROCESSING..
POS: 1361.00mm
SERVICE MENU
PRINT MENU
[MENU] key
[ ], [ ], [ ] + POWER ON
MENU
SERVICE MENU
LINEAR ENCODER
SETUP COMPLETED
LINEAR ENCODER
SETUP FAILED
LINEAR ENCODER
HEADBOARD FAILED
First, this checks if the linear encoder can be read correctly in the whole width.
Next, this calibrates the length of the linear encoder which stretches and shrink due to the environmental
temperature and humidity.
It is necessary to do this operatio if any of the followings has been performed.
-The position of Limit Sensor is adjusted.
-Limit Sensor is replaced.
-Liner Encorder is replceed
-Encoder Module is replaed.
-Main board is replaced
-All INTIALIZE is performed.
Summary of Contents for Advanced Jet AJ-1000
