Roland Advanced Jet AJ-1000, Service Notes, Page: 177 / 288

4-30
Move Head downward to the position where the surface
of Head contacts the cap when being seen crossly, then
press [ENTER] to update the adjustment value.
-When you press [ ] key, Head moves downward in 0.25mm
unit.
-When you press [ ] key, Head moves to the highest position
where the value +2.00mm.
-When you press [ ] key, the adjustment value is not updated
and the capping is carried out and then exiting the menu.
Heads are capped and you can go out from the menu without
updating the adjustment value.
5
Head moves to the position where the value is +2.00mm.
It is only possible to move Head stepwise downward.
When you move Head upward, press [ ] key to move
Head upper end once and then move downward.
4
If it is difficult to see whether Head makes
contact with the cap, irradiate Head and Cap
Top with a penlight.
In this case, move down Head while irradiating
the back plate of Head Carriage through the
gap between Head and the cap. When the
light on the back plate of Head Carriage
cannot be seen, this means that Head makes
contact with the cap.