4-51
Rotate Adjustment Screw CCW (to the direction to loosen)
when Belt is in the lower position from the center of Drive
Pulley shown in the figure.
Adjustment
Screw
NG
Screw 1
Screw 2
Screw 3
6
Tighten up Screw1 and 2 shown in the figure with pressing
Drive Shaft Support downward with 2kgf (0.2Nm). Then,
tighen up Screw 3 shown in the figure until Screw 3 hits
Scan Motor Base
with 2kgf (0.2Nm).
After tightening up screws, check that Scan Motor Base and
Drive Shaft Support is parallel.
Move Head Carriage over a few times in a whole width and
check the position of the belt on Drive Pulley again.
Screw 3
Drive Shaft Support
<Front View>
Scan Motor Base
Screw1, 2
Summary of Contents for Advanced Jet AJ-1000
