Rohde & Schwarz EVSF1000, User Manual

Page: 167 / 295

Common Instrument Settings
R&S
®
EVSF1000
167 User Manual 1178.6410.02 ─ 05
The current squelch level is indicated numerically on the softkey and graphically on the
bargraph indicator.
Remote command:
SQUELCH
on page 191
Demod
Selects between AM / FM modulation for receiver signals.
Audio BW
Frequency range to be output to the speaker or headphones.
"Full" Full bandwidth is output
"Voice (def)" Voice frequencies (> 3 kHz) filtered out
"ID Notch" ID frequency (1020 Hz) filtered out
"V/ID Notch" Voice and ID frequencies filtered out
Remote command:
SETUP:AUDIOBW
on page 189
Speaker
Enables or disables AF output at the loudspeaker on the rear panel of the
R&S
EVSF1000.
Remote command:
SETUP:SPEAKER
on page 191
KB Beep
Enables or disables a tone when a key on the keyboard is pressed. This is useful as
feedback during operation in a noisy environment.
11.2 Display
Access VNC : [v]
(Not in "Preset" view.)
Some general settings are available for the VNC display of the R&S EVSF1000.
RX Unit 1 / RX Unit 2 .................................................................................................. 167
Level View ...................................................................................................................168
RX Unit 1 / RX Unit 2
Select the receiver board whose settings and results are displayed. The currently
selected receiver board is indicated by a vertical blue line on the softkey.
This setting is only available if a second receiver board is installed (requires the
R&S
EVSG-B1 option, see Chapter 5.2, "Receiver Board" , on page 33).
While two different measurements can be performed simultaneously using two receiver
boards, the results can only be displayed for one board at a time. Use this function to
toggle between the two measurements.
Display