Data Management
R&S
®
EVSF1000
163
User Manual 1178.6410.02 ─ 05
Starting and Stopping Recording
Access VNC
: [p]
When you press the key, data is recorded to the selected list, indicated in the status
bar ("DL-LIST"). The number of data sets that the list currently contains is indicated as
"SIZE". How often and when a new data set is entered in the list depends on the
Trigger Source
Access VNC
: [k] > "F2"
Determines how often and when a new data set is entered in the list during recording.
"Time"
Data is stored in regular time intervals, defined by
"Ext."
Data is stored each time a trigger signal from a connected external
trigger device is received. The trigger device must be connected to
the "Trigger In" connector on the rear panel of the R&S
EVSF1000.
Trigger Edge
Access VNC
: [k] > "F5"
For external triggering, this setting defines whether data is stored when the positive
(rising) or negative (falling) edge of the trigger signal is received. Select the key repeat-
edly to toggle between the two settings.
Recording a single data record (GBAS/SCAT-I mode only)
Access
: [Single]
Records the selected and currently displayed slot or frame only.
This function is only available for GBAS/SCAT-I mode (R&S
EVSF1000-K4/-K5).
10.3
Creating and Storing Screenshots
Access
: [Setup] > "Screenshots"
You can create a screenshot of the current display on the R&S
EVSF1000 at any time
during operation. Creating screenshots is useful to document measurement results, for
example.
Creating and Storing Screenshots
