Rohde & Schwarz EVSF1000, User Manual

Page: 32 / 295

Measurements and Results
R&S
®
EVSF1000
32 User Manual 1178.6410.02 ─ 05
RX board (RX1 | RX2)
The currently active receiver board. See Chapter 5.2, "Receiver Board" , on page 33.
Measurement mode
The currently active measurement mode on the active receiver board, e.g. "ILS LOC".
See
Chapter 5.3, "Measurement Mode" , on page 34.
Channel (CH)
The receiver frequency channel on the active receiver board according to the ICAO fre-
quency list. See
"Channel Frequency Configuration (CH FREQ)" on page 51.
Frequency (FREQ)
The measured frequency on the active receiver board. See "Channel Frequency Con-
figuration (CH FREQ)" on page 51.
RF attenuation (Att)
The used attenuation mode; see also "RF Mode" on page 53.
Channel definition (1F/2F) - ILS LOC and ILS GP mode only
The ILS Localizer and Glidepath measurements can detect both course and clearance
data simultaneously. Alternatively, the individual channels can be measured only, or
any one or two user-defined frequencies. By default, a wideband measurement is per-
formed. The displayed measurement results depend on the selected channel and fre-
quency configuration.
See Chapter 6.1.4.1, "Channel and Frequency Configuration" , on page 49.
Level correction (Lev Corr)
The applied level correction by a transducer. See "Transducer Correction"
on page 53.
Bandwidth (IF BW)
Bandwidth on which the measurement is performed. Depends on the Channel defini-
tion (1F/2F) - ILS LOC and ILS GP mode only . See Chapter 6.1.4.3, "Bandwidth (BW)" ,
on page 53.
Measurement time (MTime)
The duration of a single measurement. See Chapter 6.1.4.4, "Setting the Measurement
Time (MTime)" , on page 55.