Rohde & Schwarz EVSF1000, User Manual

Page: 23 / 295

Getting Started
R&S
®
EVSF1000
23 User Manual 1178.6410.02 ─ 05
Measurement information for each receiver board (RX1/RX2)
In addition to the current measurement mode, measurement-specific information is
provided.
For example, for "ILS LOC" mode (see Chapter 6.1.3, "ILS Localizer and Glidepath
Measurements and Results" , on page 37):
●
"CH" : Receiver channel
●
"F" : Receiver frequency
●
"DDM" : ILS DDM
●
"SDM" : ILS SDM
●
"LEV" : Currently measured power level
●
"ID" : Decoded ID of transmitter
For details on GBAS/SCAT-I measurement information in the status display, see Chap-
ter 8.2, "GBAS/SCAT-I Status Display" , on page 117.
Network settings (NET)
See Chapter 11.3, "Network (Remote) Settings" , on page 168
●
"DHCP" : DHCP usage
●
"IP" : IP address of the R&S EVSF1000
●
"CLIENT" : IP address of connected client
Operating status of the R&S EVSF1000
See Chapter 11.5, "Instrument Configuration and Operating Status Settings" ,
on page 172
●
"HW" : Hardware status("OK"/"ERROR")
●
"GPS" : Availability of GPS signal
Current date and time
3.4.2 Basic Connection Settings
In order to operate the R&S EVSF1000 from a remote PC, you require connection
information.
By default, the R&S EVSF1000 is set to use the dynamic host configuration protocol
(DHCP), so the IP address is assigned automatically. The assigned IP address and
DHCP state of the R&S
EVSF1000 is provided in the mini display on the front panel.
Use this IP address for the initial connection from a remote PC to the R&S EVSF1000.
To change the settings, see Chapter 11.3, "Network (Remote) Settings" , on page 168.
Operating Basics