Rohde & Schwarz EVSF1000, User Manual

Page: 78 / 295

Numeric Measurement Modes
R&S
®
EVSF1000
78 User Manual 1178.6410.02 ─ 05
Bearing (from) ............................................................................................................... 78
Last ID ...........................................................................................................................78
ID Code ......................................................................................................................... 78
ID Period ....................................................................................................................... 78
Dot Length .....................................................................................................................78
Dash Length ..................................................................................................................78
Dot-Dash Gap ............................................................................................................... 78
Letter Gap ..................................................................................................................... 79
ID AM ............................................................................................................................ 79
ID Freq .......................................................................................................................... 79
Bearing (from)
Phase between both 30-Hz signals (direction of the R&S EVSF1000 in relation to the
ground station).
Remote command:
BE
on page 234
Last ID
Time since last ID pulse was measured
Remote command:
LASTID_TIME
on page 222
ID Code
Morse-decoded ID with three or four letters.
Remote command:
AC8
on page 215
AC8
on page 232
ID Period
Time between two measured ID pulses
Remote command:
ID_PERIOD
on page 222
Dot Length
Length of time a dot is transmitted in the used Morse code in milliseconds.
Remote command:
ID_DOT_LENGTH
on page 221
Dash Length
Length of time a dash is transmitted in the used Morse cod in milliseconds.
Remote command:
ID_DASH_LENGTH
on page 221
Dot-Dash Gap
Length of time that passes between a transmitted dot and a dash in the used Morse
code in milliseconds.
VOR Mode (Option R&S EVSG-K2)