Rohde & Schwarz EVSF1000, User Manual

Page: 166 / 295

Common Instrument Settings
R&S
®
EVSF1000
166 User Manual 1178.6410.02 ─ 05
11 Common Instrument Settings
Common instrument settings are applied regardless of which measurement mode is
selected.
All common instrument settings can be configured via remote commands (see
Table 3-2 ) or using a remote keyboard via VNC.
For the mapping of hard- and softkey commands to keyboard commands using VNC,
see
Table 3-2 .
Configuring screenshots is described in Chapter 10, "Data Management" ,
on page 157.
Configuring the signal input is described in
Chapter 5.1, "Input Signal Settings" ,
on page 33.
11.1 Audio Output Settings
Access VNC : [c]
(Not in "Preset" view.)
Audio output is available at the loudspeaker on the rear panel or the headphones con-
nector on the front panel of the R&S
EVSF1000.
For example, the demodulated identifier in ILS mode is output as a 1020 Hz morse sig-
nal.
AF Volume ...................................................................................................................166
Squelch ....................................................................................................................... 166
Demod .........................................................................................................................167
Audio BW .................................................................................................................... 167
Speaker .......................................................................................................................167
KB Beep ...................................................................................................................... 167
AF Volume
Defines the volume of the AF output at the at the loudspeaker or the headphones con-
nector. Enter a percentage value (0
% to 100 %).
Remote command:
SETUP:VOLUME
on page 191
Squelch
Defines the level threshold below which the demodulated data is set to 0. This is use-
ful, for example, to avoid demodulation noise during transmission breaks.
This setting is only relevant for numeric measurement modes.
The squelch level is an absolute value.
Audio Output Settings