Rohde & Schwarz EVSF1000, User Manual

Page: 58 / 295

Numeric Measurement Modes
R&S
®
EVSF1000
58 User Manual 1178.6410.02 ─ 05
You can display graphical results directly from the ILS Marker Beacon mode by select-
ing the softkey in the "Meas" menu. In this case, the settings for the current measure-
ment are applied to the graphical results.
To return from the graphical results to the ILS Marker Beacon mode, select "Return"
([F8]).
For details on the graphical results, see:
●
Chapter 7.1, "RF Spectrum Mode (Option R&S EVSG-K10)" , on page 93
●
Chapter 7.2, "IF Spectrum Mode (Option R&S EVSG-K10)" , on page 97
●
Chapter 7.3, "AF Spectrum Mode (Option R&S EVSG-K11)" , on page 102
●
Chapter 7.4, "AF Time Domain Mode (Option R&S EVSG-K12)" , on page 107
Remote command:
VIEW_MB
on page 226
● RF Level and Frequency Display ............................................................................58
● IF Spectrum Preview ...............................................................................................59
● ILS Marker Beacon Main View ................................................................................60
● ILS Marker Beacon ID Analysis .............................................................................. 61
● ILS Marker Beacon Recording View ....................................................................... 63
6.2.2.1 RF Level and Frequency Display
The measured RF power and frequency of the input signal is displayed both numeri-
cally and graphically.
Figure 6-10: RF level display
The following results are provided:
●
Numeric power level in dBm ("Lev")
For measurements on two frequencies: individual and sum power levels
●
Measured frequency offset to the nominal frequency in kHz
●
Numeric frequency offset of measured power
●
Bargraph indicating the power and a color-coded overload state, where:
–
red : overload state, check message
– yellow : power approaching overload state
– green : power in a valid range
ILS Marker Beacon Mode (Option R&S EVSG-K3)