Rohde & Schwarz EVSF1000, User Manual

Page: 55 / 295

Numeric Measurement Modes
R&S
®
EVSF1000
55 User Manual 1178.6410.02 ─ 05
Remote command:
FILTER_LLZ_RESIDFM
on page 209
6.1.4.4 Setting the Measurement Time (MTime)
Access VNC : [d]
The measurement time determines the interval at which new measurement results are
displayed. Internally, values are captured every 100
ms, that is: 10 per second. (With
the High Measurement Rate option R&S EVSG-K22 installed, the internal capture rate
is 10 ms, that is: 100 per second.) If the defined measurement time is longer, the val-
ues captured internally in that interval are averaged and only the average value is dis-
played.
Note that the measurement time determines the minimum interval for values to be
stored during recording (see
"Time" on page 161).
Enter the time in milliseconds.
Remote command:
MEASTIME
on page 182
6.1.4.5 DDM and SDM Configuration
The following settings configure the DDM and SDM measurement results.
DDM Unit .......................................................................................................................55
SDM Unit .......................................................................................................................55
ILS Phase ......................................................................................................................55
DDM Polarity ................................................................................................................. 56
DDM Bargr .................................................................................................................... 56
DDM Unit
Specifies the unit of the DDM display.
1 (dimensionless value) | % |
μ
A
Remote command:
SETUP:UNIT:DDM
on page 186
SDM Unit
Specifies the unit of the SDM display.
1 (dimensionless value) | % |
μ
A
Remote command:
SETUP:UNIT:SDM
on page 187
ILS Phase
Specifies the value range in the ILS phase.
Bipolar: -60 … +60° | Unipolar: 0 … 120°
ILS Localizer and ILS Glidepath (GP) Modes