Ricoh IM 550 Series, User Manual, Page: 278 / 344

When Other Messages Appear
• When confirming or changing the settings in [Settings], press [Home] ( ) after closing [Settings].
Message Cause Solution and reference
"Administrator
Authentication for User
Management must be set
to on before this selection
can be made." The User
Management
privilege is
disabled in the
administrator
authentication
management. When specifying Basic, Windows, or LDAP
authentication, configure the User Management
privilege in [Settings] [Machine Features
Settings] [System Settings] [Administrator
Tools] tab [Administrator Authentication
Management].
See "Registering Administrators Before Using the
Machine", User Guide (Full Version).
"Destination list / machine
settings are updated.
Selected destinations or
function settings have
been cleared. Please re-
select the settings." A destination is
being registered
and devices are
being configured
using Web Image
Monitor. Wait until the message disappears and do not turn
off the power of the machine. You may not be able
to perform operations for a while depending on the
number of destinations being registered.
"Cannot connect with the
wireless card. Turn the
main power switch off,
then check the card."
(A "wireless LAN board" is
referred to as a "wireless
card".) • The wireless
LAN board
was not
inserted
when the
machine was
turned on.
• The wireless
LAN board
was pulled
out after the
machine was
turned on.
The settings are
not updated
although the unit is
detected.
Turn off the power, and then check the wireless
LAN board is inserted correctly. After this, turn on
the power again. If the message appears again,
consult your service representative.
9. Troubleshooting
276