Printronix P8000 Series, Administrator'S Manual

Page: 319 / 422

Printing a Hex Dump
319
427:CRTG MISSING
Install new cart
Press ONLINE Yes The ribbon cartridge is
missing or installed
improperly. 1. Make sure a ribbon
cartridge is installed in the
printer.
2.
Make sure the ribbon
cartridge is seated properly.
3.
Remove and replace the
cartridge if necessary.
4.
Contact your authorized
customer service
representative.
1
428:CRTG COMM ER
See User Manual No The hardware cannot
communicate properly with
the cartridge. 1. Make sure the ribbon
cartridge is seated properly.
2.
Remove and replace the
ribbon cartridge if
necessary.
3.
Contact your authorized
service representative.
1
432:CRT NOT SET Yes The ribbon cartridge is not
correctly positioned. 1. Make sure a ribbon
cartridge is installed in the
printer.
2.
Make sure the ribbon
cartridge is seated properly.
3.
Remove and replace the
cartridge if necessary.
4.
Contact your authorized
customer service
representative.
1
435:NO WELD
See User Manual No The cartridge weld was not
detected. Contact your authorized service
representative.
1
437:REG MISSING
Use Correct RBN Yes The incorrect cartridge type
is being used for the printer. Install region X ribbon cartridge
in the printer.
NOTE: Specify the region of
the printer when
ordering ribbons.
438:TIP MISMATCH
Use Correct RBN Yes The incorrect cartridge type
is being used for the printer. Install the correct ribbon
cartridge type in the printer.
439:SHTL MISMATCH
Use Correct RBN Yes This message displays when
an Extended Life Ribbon is
mounted on a 500 lpm
printer. Install Standard Life Ribbon.
445:SD INSERTED
Reboot Printer
Yes The SD card has been
inserted after the printer was
already powered up. Turn off the printer and insert the
SD card only when the printer is
not powered on.
Table 2. LCD Message Troubleshooting Table (H-Series)
Displayed Message
Can User
Correct?
Explanation Solution
Fault Messages (H-Series with Numerical Prefix)