Printing a Hex Dump
331
SCS COMMAND
ERROR*
No
In the TN emulation, the
printer received undefined
control character (hex 40).
Contact your system
administrator.
SD CARD ERROR
Remove SD Card
Yes
The printer has been
powered up with a card in
the SD slot, but the card is
not functioning properly. The
card could be a compact
flash card or a non-
supported card.
Power down, reseat card, and
power up again. If error persists,
power down, remove card, and
try another card.
SDSC CARD
NOT SUPPORTED
Remove SD Card
Yes
The printer has been
powered up with an SDSC
card, and SDSC cards (< 4
GB) are not supported.
Power down, remove SD card,
and insert an SDHC card in the
printer.
SECURITY
VIOLATION*
No
Security code of PAL on
controller board does not
match code of firmware on
the controller board.
Contact your authorized service
representative.
1
SECURITY KEY NOT
DETECTED
No
The security key is not
present or has failed.
Contact your authorized service
representative.
1
SF ERROR
No
Structured Field Error.
Application software has
violated structured data field
parameters.
Not a printer problem. Have the
system administrator correct
applications data or
configuration.
SHUTTLE STALL
Yes
The shuttle is not moving.
Set the platen lever to match the
thickness of paper, but not too
tightly. Check and adjust the
platen gap. Inspect the ribbon
mask for deformation that snags
and interferes with shuttle
movement. If fault source is not
apparent, contact your
authorized service
representative.
1
SPX FOUND, ERROR:
KEY NOT DETECTED
No
The controller board does
not have a security key.
Contact your authorized service
representative.
1
SPX NOT NEEDED
OPTIONS ENABLED
No
The user has attempted to
use the SPX to turn on
printer options that are
already enabled.
Contact your authorized service
representative.
1
SYS R/T ERROR
No
Software issue.
Contact your authorized service
representative.
1
Table 2. LCD Message Troubleshooting Table (H-Series)
Displayed Message
Can User
Correct?
Explanation
Solution
Summary of Contents for P8000 Series
