Printronix P8000 Series, Administrator'S Manual

Page: 82 / 422

82
Chapter 4
QUICK SETUP Menu
QUICK SETUP Menu
When the printer is in offline mode, QUICK SETUP is the first Main Menu
option that appears on the control panel. The QUICK SETUP menu offers
basic menu items required to configure your printer. This section describes
the options within the QUICK SETUP menu.
NOTE: The options in your menu will vary depending on the firmware, host
IO, emulations selected, and other features available with your
printer.
Active Host
The Active Host menu enables you to select and configure interfaces between
the printer and your host computer. The Auto Switching option (factory
default) allows all ports to be active at the same time.
ZTP DataTime
This option sets the pause time in the data stream that the ZTP requires
before moving the form to the tear bar once a print job is completed. The
values range from .5 to 5 seconds. The default is .5 seconds.
ZTP WaitTime
This option sets the minimum amount of time that the form stays at the tear
bar. This allows you time to remove the form before the form is retracted to
print the next form. The adjustable values range from 500 to 5000
milliseconds in increments of 500 milliseconds. The default value is 2
seconds.
ZTP TearDist
This option sets the tear off distance from the current print position to the tear
bar. Adjustable values in increments of 1/144th of an inch range from 200 to
2880. The up and down arrows adjust the display value. When you press the
ENTER
key, the selected value is stored and a scale is printed to indicate the
current tear off position. The default value is 1060.
NOTE: When a new value is selected, the printer will lose the current print
position. You must reset the top of form to automatically save the new
value.
DBCS CPI (H-Series)
Defines the default values for horizontal character spacing in DBCS mode.
For the Hanzi and Kanji LP+ printer, select from 5.0, 6.0, 6.7, 7.5, and Others
CPI. For the Hangul LP+ printer, selected from 5.0, 6.0, 6.7, 7.5, 8.5, 10, and
others CPI.
The factory default for the Hanzi LP+ printer is 6.7 cpi. The factory default for
the Hangul LP+ printer is 6.0 cpi. The factory default for the Kanji LP+ printer
is 7.5 cpi.