Printronix P8000 Series, Administrator'S Manual

Page: 325 / 422

Printing a Hex Dump
325
BAD NVM CALL 1
BAD NVM CALL 2
BAD NVM CALL 3
BAD NVM CALL 4
BAD NVM CALL A Yes Printer firmware code error
with the Novram module that
stores configurations and
statistics. 1. Cycle power. Run the print
job again. If the message
appears, load the latest
emulation software.
2.
Cycle power. Run the print
job again. If the message
appears again, record the
exact display message and
follow the instructions on
page 296, “Diagnostics for
EXX, BAD NVM, or ILL
NVM Errors”, and contact
your authorized service
representative.
1
Bxx ERROR: NO
DOWNLOADER
FOUND No No Downloader was found
while downloading a file. Reload released Firmware.
CATASTROPHIC
ERROR No Fatal error in printer. Contact your authorized
customer service
representative.
1
CLEARING
PROGRAM FROM
FLASH No Status message: emulation
software successfully loaded
into printer RAM and the
checksum matched. The old
program is now being
deleted from flash memory. No action is required.
D50 Status
UPGRADING PANEL
No Status message: The printer
is upgrading the panel,
where %XX represents the
percentage completed. No action is required.
D51 Status %XX
Programming...
No Status message: The printer
is loading firmware, where
%XX represents the
percentage completed. No action is required.
DIAGNOSTIC
PASSED No Status message: the printer
passed its memory and
hardware initialization tests. No action is required.
DO NOT POWER OFF No Status message: The printer
is performing an operation
that must be completed
before you can cycle power. No action is required, but do not
power off the printer until the
operation is complete.
Table 2. LCD Message Troubleshooting Table (H-Series)
Displayed Message
Can User
Correct?
Explanation Solution
Fault Messages (H-Series with Numerical Prefix)