Printronix P8000 Series, Administrator'S Manual

Page: 115 / 422

3270 Params
115
Usr Defined HTRN
This option is used to set user defined lead-in characters. The range is ASCII
character. This option allows users to define their own lead-in characters for
the Printronix Specific commands. Select a hex value for the following codes
for the User Defined option:
•
Start Code 1 5F (factory default)
•
Start Code 2 5F
•
Stop Code 5B
Alt. Set 80-9F
•
Printable (factory default). Prints data in the range of hex 80 through hex
9F.
•
Control Code . Interprets data in the range of hex 80 through hex 9F as a
control code.
Change Case
Specifies the font as Mono or Dual case. This option is available only in non-
SCS mode. The host will be notified of the change when the printer is placed
online. Mono Case prints the same as Dual Case if the character set is one of
the following “right to left” sets: Katak., Hebrew, Old Hebrew, and Farsi.
SCS (System Network Architecture Character String) mode is controlled by
the host computer.
•
Dual Case (factory default)
•
Mono Case
Set Text Orientn
Specifies the direction in which characters are printed on the page. This
allows the printer to print languages which are printed right to left instead of
left to right.
•
Left to Right (factory default).
•
Right to Left . When a right to left language is selected, the host will be
notified of print direction changes when the printer is put online.
Intervention Req
Select from the following:
•
Send To Host (factory default). The printer sends a signal to the host
computer when any of the following occur:
•
Printer faults occur.
•
Hold mode time–out occurs.
•
Not Send To Host
If not selected, the printer will only send the signal on printer faults that cause
data loss (paper jam, ribbon stall, online platen open, etc.).