Printronix P8000 Series, Administrator'S Manual

Page: 375 / 422

General Commands
375
FILE_IO
(DISK_IO) RUNFILE File;Prop The RUNFILE command will open
the file named
File for printing. After
the PTX_END command is
processed, the contents of
File will
get printed before any more data is
read from the host. If the
Prop field
is present, RUNFILE will verify that
Prop matches the saved file
properties. Any mismatch will cause
the command to be ignored.
UPLOAD File;Port Reads the file named File out of the
flash file system and sends it to a
host computer via the
Port I/O port.
Port is either 1284 (for reverse
nibble or byte mode transfer using
the parallel port), or SERIAL.
NOTE: if the Ethernet option is
installed, 1284 is used to upload
across the network.
MAXSIZE Kb For backwards compatibility.
MINSIZE Kb For backwards compatibility.
OPTIMIZE (none) Causes the printer to optimize the
Flash File System. The printer
automatically reboots during this
process.
PTX_END (none) (none) Exits the PTX_SETUP.
Table 1. PTX_SETUP Commands (Non-Platform Specific) (continued)
Command Sub-Command Parameter Description