Printronix P8000 Series, Administrator'S Manual

Page: 317 / 422

Printing a Hex Dump
317
Table 2. LCD Message Troubleshooting Table (H-Series)
Displayed Message
Can User
Correct?
Explanation Solution
000:SHUTTLE TYPE
NOT SUPPORTED* No The shuttle type was not
detected at power-up or the
shuttle installed in the printer
is not supported by the
firmware. Contact your authorized service
representative.
1
104:POWER SUPPLY
HOT Yes Power supply sensors report
high temperatures. Check printer environment. If hot
or dusty, relocate printer.
Contact your authorized service
representative if this occurs
frequently.
1
105:PRINTER HOT Yes This message indicates
internal temperatures of 80°
Celsius or higher (176°
Fahrenheit). Check printer environment. If hot
or dusty, relocate printer.
Contact your authorized service
representative if this occurs
frequently.
1
401:BUFFER
OVERRUN Yes The print buffer has
overflowed on a serial
interface. The printed output
may contain random *
(asterisk) characters. Make
a configuration printout. Verify that the printer matches
the host serial interface
configuration settings for Data
Protocol, Baud Rate, Data Bits,
Stop Bits, Parity, Data Terminal
Ready, and Request to Send.
Set printer serial interface
parameters to match those of
the host.
402:CLEAR PAPER
JAM Yes No paper motion. Clear jam and reload paper. If
this message recurs, contact
your authorized service
representative.
1
403:CLOSE PLATEN Yes The platen lever is open. Close the platen lever.
409:FRAMING ERROR Yes The printed output may
contain random !
(exclamation point)
characters. Make a configuration printout.
Set printer serial interface
parameters to match host
configuration settings for Data
Protocol, Baud Rate, Data Bits,
Stop Bits, Parity, Data Terminal
Ready, and Request to Send.
410:LOAD PAPER Yes Printer is out of paper. Load paper and press CLEAR .
411:PARITY ERROR Yes The printed output may
contain a random ?
(question mark) characters. Check your printer serial
interface parameter settings; if
necessary, adjust them so that
they match the settings of the
attached host.
Fault Messages (H-Series with Numerical Prefix)