Printronix P8000 Series, Administrator'S Manual

Page: 305 / 422

Printing a Hex Dump
305
FIRMWARE ERROR* No Application software tried
to perform an illegal
printer function or
damaged memory
detected on the controller
board. Contact your authorized
service representative.
1
FLASH: CHECK RETURN No Printer encountered an
error while trying to
program Flash memory. Contact your authorized
service representative.
1
FLASH: WAS NOT
CLEARED No Printer encountered an
error while trying to
program Flash memory. Contact your authorized
service representative.
1
FLASH: WRITE ERROR # 2 No Printer encountered an
error while trying to
program Flash memory. Contact your authorized
service representative.
1
FM HEADER ERROR* No Frame Header Error.
Application software has
violated header
parameters. Contact your system
administrator.
FRAMING ERROR Yes The printed output may
contain random !
(exclamation point)
characters. Make a configuration printout.
Set printer serial interface
parameters to match host
configuration settings for Data
Protocol, Baud Rate, Data
Bits, Stop Bits, Parity, Data
Terminal Ready, and Request
to Send.
GENERATING XX%
NAND FLASH TABLE
No NAND FLASH is being
read and system tables
are being initialized. No action is required.
H00: PCI SLOT ?
See User Manual No The controller board is
not communicating with a
PCI card. This could
indicate a bad PCI card,
poor connection, or
problem in the PCI bus. Contact your authorized
service representative.
1
H01: PCI J12
See User Manual No The controller board is
not communicating with
the PCI card in PCI slot
J12. This could indicate a
bad PCI card, poor
connection, or problem in
the PCI bus. Contact your authorized
service representative.
1
Table 1. LCD Message Troubleshooting Table (ASCII)
Displayed Message
Can User
Correct?
Explanation Solution
Fault Messages (ASCII in Alphabetical Order)