Printronix P8000 Series, Administrator'S Manual

Page: 330 / 422

330
Chapter 8
Fault Messages (H-Series with Numerical Prefix)
LOADING PROGRAM
INTO FLASH No The printer has deleted the
previous program from flash
memory and is loading the
new program into flash
memory. No action is required.
NEW SPX DETECTED
PRESS ENTER
No The printer detects an SPX
installed at the debug port
and the SPX is valid for the
printer. Contact your authorized service
representative.
1
NON VOLATILE
MEMORY FAILED No Large emulations reduce the
amount of space available
for saving configurations,
which means that
sometimes fewer than eight
configurations can be saved. Contact your authorized service
representative.
1
ONLINE N/A Printer state message:
printer is online and in
communication with host. No action is required.
PANEL
BAD CHECKSUM
No Panel Code has a bad
Checksum. Reload released firmware.
PARAMETER ERROR* No Illegal parameter value
received in command code
over a TN emulation. Contact your authorized service
representative.
1
PLAT DRVR CIR No Platen driver circuit
malfunction. Contact your authorized service
representative.
1
PLEASE WAIT...
RESET IN
PROGRESS
N/A Status message: the printer
finished loading the program
into flash memory and is
automatically resetting itself. No action is required.
PRINTER UNDER
REMOTE CONTROL No Status message: The printer
is under the control of
PrintNet Enterprise (PNE)
remote management
software. No action is required.
PROCESSOR
HALTED
EC_FAULT_RTSYS2 No Real-time System Firmware
error on controller board. Contact your authorized service
representative.
1
REMOVE USED SPX
THEN PRESS ENTER
No Status message: An SPX is
depleted because it has
successfully reprogrammed
the security key on the
controller board. Contact your authorized service
representative.
1
RESTORING BOOT
CODE No Normal download
initialization message. No action is required.
Table 2. LCD Message Troubleshooting Table (H-Series)
Displayed Message
Can User
Correct?
Explanation Solution