Printronix P8000 Series, Administrator'S Manual

Page: 327 / 422

Printing a Hex Dump
327
E-Net Test Unavailable Yes The ethernet PCBA did not
initialize correctly. Cycle power. Wait for “E-Net
Ready” to display, then retry
operation. If it still fails, contact
your authorized service
representative.
1
ERROR NOR
FLASHED WAS
NOT CLEARED
No Problem programming Boot
Code. Contact your authorized service
representative.
1
ERROR: DC
PROGRAM NOT
VALID Yes The printer cannot find the
data controller program or
the validation checksum is
corrupt. Download the program again. If
the message appears, contact
your authorized service
representative.
1
ERROR: LOCKED
SN=nnnnnnnnnnnnnnn
nnnnnn No nnnnnnnnnnnnnnnnnnnnn is
the serial number of the
printer’s security key. The
SPX serial number does not
match the printer’s serial
number and cannot be used
with the printer. Contact your authorized service
representative.
1
ERROR: NVRAM
FAILURE No The non-volatile SRAM on
the controller board has
failed. Contact your authorized service
representative.
1
ERROR: PROGRAM
NOT COMPATIBLE Yes The printer is not compatible
with the downloaded
program. Use the correct emulation
software options(s) for this
printer model.
ERROR: PROGRAM
NOT VALID Yes The printer does not see a
program in flash memory. There is no program in printer
memory. Download the
emulation.
ERROR: SECURITY
KEY NOT DETECTED No The security key is not
present or failed. Contact your authorized service
representative.
1
ERROR: WRONG
CHECKSUM No The printer received the
complete program but the
checksum did not match.
The data may have been
corrupted during
downloading. Contact your authorized service
representative.
1
ERROR: WRONG
OEM No The SPX inserted in the
debug port is not intended
for this model printer or this
OEM. Contact your authorized service
representative.
1
ERROR: WRONG
PRINTER TYPE No The SPX inserted in the
debug port is not intended
for this model printer or this
OEM. Contact your authorized service
representative.
1
Table 2. LCD Message Troubleshooting Table (H-Series)
Displayed Message
Can User
Correct?
Explanation Solution
Fault Messages (H-Series with Numerical Prefix)