Printronix P8000 Series, Administrator'S Manual

Page: 84 / 422

84
Chapter 4
QUICK SETUP Menu
PGL SFCC
You can specify which hex code (1-FF) will be used as the Special Function
Control Character (SFCC). The SFCC denotes that the following data is an
IGP command.
•
7E (factory default)
•
1 – FF
VGL SFCC
You can specify which hex code (1-FF) will be used as the Special Function
Control Character (SFCC). The SFCC denotes that the following data is an
IGP command.
•
5E (factory default)
•
1 – FF
Active Protocol
Select the Line protocol you wish to use. Refer to the LinePrinter Plus
Programmer's Reference Manual for more information.
Form Length
Form length is the number of lines that can be printed on a page. You can set
the form length in inches, millimeters (mm), or as a function of the current lpi
(lines per inch).
Form Width
The form width can be specified in inches, millimeters, or as a function of the
current cpi (characters per inch). The forms width set should not exceed the
actual paper width.
Select CPI
This parameter allows you to specify the characters per inch (cpi) values.
The options are 10.0, 12.0, 13.3, 15.0, 17.1, and 20.0. The factory default is
10.0 CPI. Also, 6.0 CPI is available for Indian Language firmware.
Select LPI
This parameter allows you to specify the lines per inch (lpi) values.
•
ASCII : The options are 6.0, 8.0, 9.0 and 10.3 LPI. The factory default is
6.0 LPI.
•
Indian Language : All ASCII options are available with additional options
3.0, 4.0, 4.5, and 5.0 LPI.
•
H-Series : The options are 6.0 or 8.0 LPI. The factory default for the Hanzi
and Hangul LP+ is 6.0. The factory default for Kanji LP+ is 8.0.