NXP Semiconductors KE1xF Series, Reference Manual, Page: 1115 / 1483

register (item 3). In this case, use the software output control ( Software Output Control
Mode ) or the initialization ( Initialization ) to update the channel output to the selected
value (item 4).
(1) FTM reset
0x0015 0x0014 0x0013 0x0012 . . . 0x0010 0x0017 0x0016 XXXX 0x0000 0x0011 FTM counter
CLKS[1:0]
channel (n) output
(5) write 1 to SC[CLKS]
(3) write any value
to CNT register
(2) FTM configuration channel (n) pin is controlled by FTM
NOTES:
– CNTIN = 0x0010
– Channel (n) is in output compare and the channel (n) output is toggled when there is a match
– C(n)V = 0x0014
00 XX 01
(4) use of software output control or initialization
to update the channel output to the zero
Figure 41-111. FTM behavior after reset when the channel (n) is in Output Compare
mode
41.7 FTM Interrupts
41.7.1 Timer Overflow Interrupt
The timer overflow interrupt is generated when (TOIE = 1) and (TOF = 1).
41.7.2 Reload Point Interrupt
The Reload Point interrupt is generated when (RIE = 1) and (RF = 1).
41.7.3 Channel (n) Interrupt
The channel (n) interrupt is generated when (CHIE = 1) and (CHF = 1).
Chapter 41 FlexTimer Module (FTM)
Kinetis KE1xF Sub-Family Reference Manual, Rev. 4, 06/2019
NXP Semiconductors 1115