NXP Semiconductors KE1xF Series, Reference Manual, Page: 795 / 1483

The configuration of each Pin Control register is retained when the PORT module is
disabled.
Whenever a pin is configured in any digital pin muxing mode, the input buffer for that
pin is enabled allowing the pin state to be read via the corresponding GPIO Port Data
Input Register (GPIO_PDIR) or allowing a pin interrupt or DMA request to be generated.
If a pin is ever floating when its input buffer is enabled, then this can cause an increase in
power consumption and must be avoided. A pin can be floating due to an input pin that is
not connected or an output pin that has tri-stated (output buffer is disabled).
Enabling the internal pull resistor (or implementing an external pull resistor) will ensure a
pin does not float when its input buffer is enabled; note that the internal pull resistor is
automatically disabled whenever the output buffer is enabled allowing the Pull Enable bit
to remain set. Configuring the Pin Muxing mode to disabled or analog will disable the
pin’s input buffer and results in the lowest power consumption.
35.7.2 Global pin control
The two global pin control registers allow a single register write to update the lower half
of the pin control register on up to 16 pins, all with the same value. Registers that are
locked cannot be written using the global pin control registers.
The global pin control registers are designed to enable software to quickly configure
multiple pins within the one port for the same peripheral function. However, the interrupt
functions cannot be configured using the global pin control registers.
The global pin control registers are write-only registers, that always read as 0.
35.7.3 External interrupts
The external interrupt capability of the PORT module is available in all digital pin
muxing modes provided the PORT module is enabled.
Each pin can be individually configured for any of the following external interrupt
modes:
• Interrupt disabled, default out of reset
• Active high level sensitive interrupt
• Active low level sensitive interrupt
• Rising edge sensitive interrupt
• Falling edge sensitive interrupt
• Rising and falling edge sensitive interrupt
Chapter 35 Port Control and Interrupts (PORT)
Kinetis KE1xF Sub-Family Reference Manual, Rev. 4, 06/2019
NXP Semiconductors 795