Nord Drivesystems SK 200E Series, Manual

Page: 190 / 265

NORDAC SK 200E Manual
190 Subject to technical alterations BU 0200 GB
Parameter Setting value / Description / Note Device Supervisor
Parameter
set
P705
[-01]
...
[-05]
DC l i nk volt age last er ror 1...5
S
0 ... 1000 V DC This parameter stores the link voltage that was being delivered at the time the error occurred.
The values of the last 5 errors are stored.
With the SimpleBox, the corresponding memory location 1...5- (Array parameter) must be
selected and confirmed using the OK key to read the stored error code.
P706
[-01]
...
[-05]
P arameter set, last error 1...5
S
0 ... 3 This parameter stores the parameter set code that was active when the error occurred. Data for
the previous 5 faults are stored.
With the SimpleBox, the corresponding memory location 1...5- (Array parameter) must be
selected and confirmed using the OK key to read the stored error code.
P707
[-01]
...
[-03]
Software version / revision
0.0 ... 9999.9 This parameter shows the software and
revision numbers in the FI. This can be
significant when different FIs are assigned
the same settings.
Array [-03] provides information about any
special versions of the hardware or
software A zero stands for the standard
version.
[-01] = Software version, version number (V1.0)
[-02] = Software revision, revision number (R1)
[-03] = Special version , of the
hardware/software (0.0)
P708 State of digital in puts
Displays the status of the digital inputs in binary/hexadecimal code. This display can be used to
check the input signals.
Bit 0 = Digital input 1
Bit 1 = Digital input 2
Bit 2 =
Digital input 3
Bit 3 = Digital input 4
Bit 4 = PTC resistor input
Bit 4 Bits 3 -0
Minimum value
0
0
0000
0
Binary
hex
Maximum value
1
1
1111
F
Binary
hex
00000 ... 11111
(bin)
or
00 ... 1F
(hex)
SimpleBox: The binary Bits are converted into a hexadecimal value and displayed.
ParameterBox: The Bits are displayed with increasing values from right to left (binary).