NF FRA51602, Instruction Manual

Page: 252 / 286

9.3 Measurement processing section
9
-
6
FRA 51602
Figure 9-2 Isolation voltage specifications between signal connectors
When cables or probes, etc. are connected to the instrument, the voltage is restricted to the withstand
voltage specifications of the connected cable or probe, etc. or to the withstand voltage of the instrument,
whichever voltage is lowest.
9.3 Measurement processing section

Measurement operations
SPOT Do a measurement at the current frequency (no sweep)
UP SWEEP Do a sweep measurement (in order of increasing frequency)
DOWN SWEEP Do a sweep measurement (in order of decreasing frequency)
REPEAT Do measurements repeatedly
SINGLE Do a single measurement

Measurement delay function
This function delays the beginning of a measurement after the frequency is changed.
Delay can be set either a duration or a number of cycles.
Time settings
Setting range 0 to 9,990 s
Setting resolution 3 digits or 0.1 ms, whichever is greater
Cycle settings (set in units of measurement frequency cycle)
Setting range 0 to 9,999 cycles, but no more than 9,990 s
Setting resolution 1 cycle

Start delay function
This function delays the beginning of a measurement only from the start of a sweep or spot measurement.
Delay can be set either a duration or a number of cycles.
Time settings
Setting range 0 to 9,990 s
Setting resolution 3 digits or 0.1 ms, whichever is greater
Cycle settings (Set in units of measurement frequency cycles)
Setting range 0 to 9,999 cycles, but no more than 9,990 s
Setting resolution 1 cycle

Integration function
This function performs integration on measurement data to remove the effects of noise. Measurement
repetition can be set either a number of cycles or a duration.
Time setting
OSC CH1 CH2
600 V CAT
Ⅱ
300 V CAT
Ⅲ
600 V CAT
Ⅱ
300 V CAT
Ⅲ
600 V CAT
Ⅱ
300 V CAT
Ⅲ