Motor Power Company DUET_FL 48/10, User Manual

Page: 69 / 196

Page 69
 Through the digital inputs:
The destinations are selected through the digital inputs (DIN0…DIN5).
When there is a rising edge at digital input DIN6, the destination is adopted and the positioning
run is started. Information on how to configure the digital inputs for the positioning run can be
found in
chapter 5.3 Digital inputs DIN0 to DIN9 .
 Through the serial interface:
The movement to the destination position and the homing run can be started via the
parametrization program. To do so, activate the menu
Parameters/Positioning/Go to
destination . You can move to the desired destination by clicking on the corresponding button.
You can also click the GO! button to start a positioning run and to move to the destination
currently being displayed (see also chapter position sets ).
In the lower section of the
window, you can make settings for the course program. If you select Course Program
active , the course program will be enabled in the positioning mode. The
button opens the course program menu (see
chapter Course program
). In addition you
can define two start lines for the course program.
User Manual DUET_FL „DUET_FL 48/10“ Version 1.1 Motor Power Company