Motor Power Company DUET_FL 48/10, User Manual

Page: 58 / 196

Page 58
Speed-controlled mode
The setpoint management system includes a ramp generator. Any of the above-mentioned setpoint
sources can be selected under
Selector: Speed setpoint and run through the ramp generator. You
can also select another addition setpoint source, Selector: Correcting setpoint . This other setpoint
source, however, will not be fed through the ramp generator. The total setpoint is a summation of the
two values. The acceleration and deceleration time of the ramp can be parametrized depending on the
direction.
In the speed setpoint selector menu shown above, you can also activate the torque limitation. This is
symmetrically possible and the limitation source can be selected as desired.
Torque-controlled mode
If you select the Torque control tab, you can select any of the above-mentioned setpoint sources
under Selector: Torque setpoint . However, the ramp generator and the correcting setpoint are not
available in torque-controlled mode.
You can also activate the torque limitation.
If an analog input is activated as the setpoint source but the menu does not show a line
towards the setpoint, the digital inputs may be activated. (See
chapter Configuring the
digital inputs )
User Manual DUET_FL „DUET_FL 48/10“ Version 1.1 Motor Power Company