Leibinger JET3 up, Operating Manual

Page: 377 / 412

Group 10 Setting-up/Maintenance Page 375
JET3up Release R1.06
Example: Solvent refill bottle in screwed on position
Screw the still sealed re-fill bottle on the corresponding reservoir tank. The seal of
the bottle will be breached while the bottle is screwed on the tank, the closing valve
of the tank will open automatically and the reservoir tank is filled up. Do not remove
the re-filling bottle until it is complete empty. When the printer gives you a refilling
message the reservoir tank is empty so that a complete bottle can be filled in.
Twist off the empty re-filling bottle. The closing valve of the corresponding reservoir
tank will be closed automatically. Finally screw up the cap of the reservoir tank as
well as the empty refill bottle carefully.
Attention
Important hints!
Do not dispose the empty bottles before you have activated the ink or
the solvent!
After filling the reservoir tanks as well as the empty refill bottles, they
have to be closed carefully again.
You have absolutely to fill in the complete bottle because the bottle
will be devaluated and can be not activated anymore!
11. When you refilled the reservoir tanks without the activation of an ink or a
solvent after a little while one or both of the following message will be displayed.
One is requested to carry out the TAG-activation of the refilled ink or solvent
afterwards.
12. Carry out the TAG activation as described in points 3. to 9 .