Leibinger JET3 up, Operating Manual

Page: 113 / 412

Group 8 Job Editor Page 111
JET3up Release R1.06
7.2.5.2 Create new job lists – Example : Extern Jobselect with distances
Task:
This example is based on the last example (see 7.2.5.1 ).
Three different print jobs shall be printed. The print-out shall not be carried out in a
fixed order but on the basis of direct addressing each print job. The addresses of
the print jobs shall be 1, 5 and 7 and the print order 1-7-5-5-1. The job list is the
same as for Example 1 but the parameters of the single print jobs are different.
For this example the following parameters were added to each print job:
Print job
address
Print job PrintGo
delay [mm]
PrintGo
distance [mm]
PrintGo
repetition
endless
1 JL-Job1 0 60 2 no
5 JL-Job2 20 50 3 no
7 JL-Job3 30 70 1 no
Presets:
The presets for this example are the same as for example 1.
Settings:
The joblist settings are the same as for example 1.
Approach:
The numbers in brackets refer to the pictures in
Figure 37.
1. Open the job list with the <Load Joblist to print> (1-3) .
2. Apply the address of the print job at the first position of the job list to the
X4 connector (decimal=1; 10-bit binary=0000000001) (4) .
3. With the next <PrintGo> signal the addressed print job will be printed. For
this print job the <PrintGo delay> is set to 0 mm. Therefore the printout
will start directly with the <PrintGo> signal (6) . <PrintGo repetition> is
set to two and the <PrintGo distance> is set to 60 mm. Therefore there
will be a total of three printouts
(6)
and the distances between the first dots
of each printout/repetition will be 60 mm
(7)
.
4. Apply the address of the print job at the seventh position of the job list to
the X4 connector (decimal=7; 10-bit binary=0000000111) (13) (8).
5. With the next <PrintGo> signal the addressed print job will be printed. For
this print job the <PrintGo delay> is set to 30 mm. Therefore the printout
will start 30 mm after the position where the <PrintGo> signal occurred
(9) . <PrintGo repetition> is set to 1 and the <PrintGo distance> is set to
70 mm. Therefore there will be a total of two print (10) outs and the
distances between the first dots of each printout/repetition will be 70 mm
(11) .
6. Apply the address of the print job at the fifth position of the job list to the
X4 connector (decimal=5; 10-bit binary=0000000101 (12).