Leibinger JET3 up, Operating Manual

Page: 107 / 412

Group 8 Job Editor Page 105
JET3up Release R1.06
Encoder Parameter (27)
<Encoder Source> (28) The encoder source can either be external
(hardware encoder) or internal (defining the
speed).
<Resolution> (29) In this display field the resolution of the used
encoder has to be defined in pulses per millimeter.
<intern Speed> (30) There has to be an internal speed defined in case
no external encoder is used.
<Encoder/Direction> (31)
For an external encoder it can be defined which
rotational directions shall be detected.
<Speed dependent
output> (32)
The digital outputs of the JET3up printer can be
linked with the measured speed. The assigned
output switches to high level once the set speed is
reached /exceeded. The assigned output switches
back to low level when the speed falls 10% below
the set speed.
Please see chapter
8.5.3.5 Speed dependent
output for details.
<Sensor distance> (33) Distance parameter if the speed is measured by
two sensors instead of an encoder.
<use encoder direction for
mirror> (34)
The directional information of the encoder can be
used to mirror the print out.
<lock backward> (35) With this option selected the backward
movements of an external encoder will be ignored.
Date Change Parameter (36)
<Date Change Offset> (37)
There can be defined a date change offset with
a maximum of 23 hours and 59 minutes. The
offset can be defined as positive or negative
offset. E.g. with an offset of +3 the date would
not change at 00:00 but at 03:00.