Leibinger JET3 up, Operating Manual

Page: 122 / 412

Page 120 Job Editor Group 8
Release R1.06 JET3up
Printstyle (5)
<Print height> Default (80%)
<Orientation> Default (0°)
<mirrored>
Default (no)
Print Parameter (6)
<PrintGo Distance> 150 mm
<PrintGo Repeat> 1
<endless>
Not selected
<PrintGo Source> <Extern> and <positive edge> .
<PrintStop interrupts print-
out immediately>
Default (no)
<PrintGo Gate> Default (no)
Encoder Parameter (7)
<Encoder Source> Extern
<Resolution> 12.500
<intern Speed> Not available if an external encoder is used
<Encoder/Direction> Clockwise
<Speed dependent output>
Not used. Default (700)
<lock backward>
yes
Date Change Parameter (8)
<Date Change Offset> Default (0)
7. Save the created job list (9-10) .
8. Open the job list with the <Load Joblist to print> command (11-12) .
9. Get the printer ready to print (open nozzle seal, push green
<PrintStart>
button).
10. The <PrintGo> signal sets the reference point for all distances assigned to
the print jobs on the job list. The first print job of the job list will be printed
in a distance of 30 mm to that reference point (13) .
11. The second print job of the job list will be printed in a distance of 70 mm to
the reference point (13) .
12. The third print job of the job list will be printed in a distance of 110 mm to
the reference point.
(13)
.
13. In the <PrintGo Parameters> of the <Joblist Settings> parameter for
<PrintGo distance> and <PrintGo repetition> were set. The <PrintGo
distance> was set to 150 mm and there shall be one repetition. Therefore
all three jobs on job list will be printed again in the same matter as described
in points 9-11. The repetition will start 150 mm from the reference point
(13)
.
14. The task is finished.