Leibinger JET3 up, Operating Manual

Page: 110 / 412

Page 108 Job Editor Group 8
Release R1.06 JET3up
Printstyle (5)
<Print height> Default (80%)
<Orientation> Default (0°)
<mirrored>
Default (no)
PrintGo Parameter (6)
<PrintGo Distance>
Not available for
<Extern Joblist>
. This para-
meter can be defined within each print job. It will
only affect print jobs with repetitions.
<PrintGo Repeat> Not available for <Extern Joblist>. This para-
meter can be defined within each print job.
Distances between repetitions are defined with
the <PrintGo Distance> parameter within the
print job.
<endless>
Not available for
<Extern Joblist>
This para-
meter can be defined within each print job.
<PrintGo Source> <Extern> and <positive edge> .
<PrintStop interrupts print-
out immediately>
Default (no)
<PrintGo Gate> Default (no)
Encoder Parameter (7)
<Encoder Source> Extern
<Resolution> 12.500
<intern Speed>
Not available if an external encoder is used
<Encoder/Direction> Clockwise
<Speed dependent output> Not used. Default (700)
<lock backward> yes
Date Change Parameter (8)
<Date Change Offset> Default (0)
6. Save the created job list (9-10) .
7. Open the job list with the
<Load Joblist to print> (11-12)
.
8. Get the printer ready to print (open nozzle seal, push green <PrintStart>
button).
9. Apply the address of the print job at the first position of the job list to the
X4 connector (decimal=1; 10-bit binary=0000000001) (13) .
10. With the next <PrintGo> signal the addressed print job will be printed.
11. Apply the address of the print job at the seventh position of the job list to
the X4 connector (decimal=7; 10-bit binary=0000000111) (13).
12. With the next <PrintGo> signal the addressed print job will be printed.
13. Apply the address of the print job at the fifth position of the job list to the
X4 connector (decimal=5; 10-bit binary=0000000101 (13).
14. With the next <PrintGo> signal the addressed print job will be printed.