Parameter description:
Rate Limiter ID:
The rate limiter ID for the settings contained in the same row.
Rate
The allowed values are: 0-3276700 in pps or 0, 100, 200, 300, ..., 1000000 in kbps.
Unit:
Specify the rate unit. The allowed values are:
pps: packets per second.
kbps: Kbits per second.
Buttons
Save – Click to save changes.
Reset – Click to undo any changes made locally and revert to previously saved values.
3.2.3 Access Control List
The section describes how to configure Access Control List rules. An Access Control List (ACL) is a sequential list of permit
or deny conditions that apply to IP addresses, MAC addresses, or other more specific criteria. This switch tests ingress
packets against the conditions in an ACL one by one. A packet will be accepted as soon as it matches a permit rule, or
dropped as soon as it matches a deny rule. If no rules match, the frame is accepted. Other actions can also be invoked
when a matching packet is found, including rate limiting, copying matching packets to another port or to the system
log, or shutting down a port.
This page shows the Access Control List (ACL), which is made up of the ACEs defined on this switch. Each row describes
the ACE that is defined. The maximum number of ACEs is 256 on each switch. Click on the lowest plus sign to add a
new ACE to the list. The reserved ACEs are used for internal protocol and cannot be edited or deleted, the order sequence
cannot be changed and the priority is highest
Web Interface
To configure Access Control Lists in the web interface:
23
LANCOM GS-2310P/GS-2326(P) User Manual
3 Configuration
