The logical port for the settings contained in the same row.
Mode:
Select mirror mode.
Rx only Frames received on this port are mirrored on the mirror port. Frames transmitted are not mirrored.
Tx only Frames transmitted on this port are mirrored on the mirror port. Frames received are not mirrored.
Disabled Neither frames transmitted nor frames received are mirrored.
Enabled Frames received and frames transmitted are mirrored on the mirror port.
5
For a given port, a frame is only transmitted once. It is therefore not possible to mirror Tx frames on the mirror
port. Because of this, mode for the selected mirror port is limited to Disabled or Rx only.
Buttons:
Save – Click to save changes.
Reset – Click to undo any changes made locally and revert to previously saved values.
3.21 Trap Event Severity
The function is used to send an Alarm trap and get the Event log. The Trap Events Configuration function is used to
enable the switch to send out the trap information when pre-defined trap events occure.
Web Interface
To configure the Trap Event Severity in the web interface:
1. Click Configuration, Trap Event Severity Configuration
2. Select the Group name and Severity Level
3. Click Apply to save the setting
4. If you want to cancel the setting then you need to click the Reset button. It will revert to previously saved values.
Figure 3-21.1: The Trap Event Severity Configuration
134
LANCOM GS-2310P/GS-2326(P) User Manual
3 Configuration
