The destination IPv6 Address
Ping Size:
The payload size of the ICMP packet. Values range from 8 bytes to 1400 bytes.
Start:
Click the “Start” button, the switch will start to ping the device using the set ICMPv6 packet size.
Once you pressed "Start", 5 ICMPv6 packets are transmitted, and the sequence number and roundtrip time are displayed
upon reception of a reply. The page refreshes automatically until responses to all packets are received, or until a timeout
occurs.
PING6 server 2001:db8::201
64 bytes from 2001:db8::201: icmp_seq=0, time=0ms
64 bytes from 2001:db8::201: icmp_seq=1, time=0ms
64 bytes from 2001:db8::201: icmp_seq=2, time=0ms
64 bytes from 2001:db8::201: icmp_seq=3, time=0ms
64 bytes from 2001:db8::201: icmp_seq=4, time=0ms
Sent 5 packets, received 5 OK, 0 bad
You can configure the following properties of the issued ICMP packets:
6.5.3 VeriPHY (GS-2326(P) only)
This section is used for running the VeriPHY Cable Diagnostics. Press "Start" to run the diagnostics. This will take
approximately 5 seconds. If all ports are selected, this can take approximately 15 seconds. When completed, the page
refreshes automatically, and you can view the cable diagnostics results in the cable status table. Note that VeriPHY is
only accurate for cables of length 7 -140 meters.10 and 100 Mbps ports will be linked down while running VeriPHY.
Therefore, running VeriPHY on a 10 or 100 Mbps management port will cause the switch to stop responding until VeriPHY
is complete.
Web Interface
To configure VeriPHY Cable Diagnostics in the web interface:
1. Specify Port which want to check.
2. Click Start.
Figure 6-5.3: The VeriPHY
Parameter description:
Port:
The port where you are requesting VeriPHY Cable Diagnostics.
204
LANCOM GS-2310P/GS-2326(P) User Manual
6 Maintenance
