Parameter description:
Mode of IP Source Guard Configuration:
Enable the Global IP Source Guard or disable the Global IP Source Guard. All configured ACEs will be lost when the mode
is enabled.
Port Mode Configuration:
Specify IP Source Guard is enabled on which ports. Only when both Global Mode and Port Mode on a given port are
enabled, IP Source Guard is enabled on this given port.
Max Dynamic Clients:
Specify the maximum number of dynamic clients that can be learned on given port. This value can be 0, 1, 2 or unlimited.
If the port mode is enabled and the value of max dynamic client is equal to 0, it means only allow the IP packets forwarding
that are matched in static entries on the specific port.
Buttons:
Save – Click to save changes.
Reset – Click to undo any changes made locally and revert to previously saved values.
5.1.2 Static Table
The section describes how to configure the Static IP Source Guard Table parameters of the switch. You could use the
Static IP Source Guard Table configure to manage the entries.
Web Interface
To configure a Static IP Source Guard Table in the web interface:
1. Click “Add new entry”.
2. Specify the Port, VLAN ID, IP Address, and MAC address in the entry.
3. Click Apply.
Figure 5-1.2: The Static IP Source Guard Table
Parameter description:
Delete:
Delete the entry. It will be deleted during the next save.
161
LANCOM GS-2310P/GS-2326(P) User Manual
5 Security
