Indicates the classification action taken on ingress frame if parameters configured are matched with the frame's content.
There are three action fields: Class, DPL and DSCP.
Class: Classified QoS Class; if a frame matches the QCE it will be put in the queue.
DPL: Drop Precedence Level; if a frame matches the QCE then DP level will set to value displayed under DPL column.
DSCP: If a frame matches the QCE then DSCP will be classified with the value displayed under DSCP column.
Conflict:
Displays QCE status. It may happen that resources required to add a QCE may not available, in that case it shows conflict
status as 'Yes', otherwise it is always 'No’. Please note that conflict can be resolved by releasing the resource required
by the QCE and pressing 'Refresh' button.
Auto-refresh:
Activate the auto-refresh to refresh the information automatically.
Resolve Conflict:
Click it to resolve the conflict issue.
Refresh:
Refresh the QCL information manually.
3.14.12 Storm Control
The section shows how to configure the Storm control of the switch. There is a unicast storm rate control, multicast storm
rate control, and a broadcast storm rate control. These only affect flooded frames, i.e. frames with a (VLAN ID, DMAC)
pair not present on the MAC Address table. The configuration indicates the permitted packet rate for unicast, multicast
or broadcast traffic across the switch
Web Interface
To configure the Storm Control Configuration parameters in the web interface:
1. Click Configuration, QoS, Storm Control Configuration
2. Activate to select the frame type to enable storm control
3. Set the Rate Parameters
4. Click Apply to save the setting
5. If you want to cancel the setting then you need to click the Reset button. It will revert to previously saved values
Figure 3-14.12: The Storm Control Configuration
Parameter description:
Frame Type:
The settings in a particular row apply to the frame type listed here: Unicast, Multicast or Broadcast.
Enable:
120
LANCOM GS-2310P/GS-2326(P) User Manual
3 Configuration
