Save – Click to save changes.
Reset – Click to undo any changes made locally and revert to previously saved values.
3.6.2 VLAN Configuration
When MLD snooping is enabled on a VLAN, the switch acts to minimize unnecessary multicast traffic. If the switch
receives multicast traffic destined for a given multicast address, it forwards that traffic only to ports on the VLAN that
have MLD hosts for that address. It drops that traffic for ports on the VLAN that have no MLD hosts
It will use the last entry of the currently displayed entry as a basis for the next lookup. When the end is reached the text
"No more entries" is shown in the displayed table.
Web Interface
To configure the MLD Snooping VLAN in the web interface:
1. Click Configuration, MLD Snooping, VLAN Configuration
2. Specify the VLAN ID with entries per page.
3. Click “Refresh“ to refresh a entry of the MLD Snooping VLAN Configuration Information.
4. Click “<< or >>“ to move to previous or next entry.
Figure 3-7.2: The MLD Snooping VLAN Configuration.
Parameter description:
VLAN ID:
The VLAN ID of the entry.
Snooping Enabled:
Enable the per-VLAN MLD Snooping. Only up to 32 VLANs can be selected.
MLD Querier:
A router sends MLD Query messages onto a particular link. This Router is called the Querier. Enable the MLD Querier in
the VLAN.
Compatibility:
Compatibility is maintained by hosts and routers taking appropriate actions depending on the versions of MLD operating
on hosts and routers within a network. The allowed selection is MLD-Auto, Forced MLDv1, Forced MLDv2, default
compatibility value is MLD-Auto.
Rv:
Robustness Variable. The Robustness Variable allows tuning for the expected packet loss on a network. The allowed
range is 1 to 255; default robustness variable value is 2.
QI:
Query Interval. The Query Interval is the interval between General Queries sent by the Querier. The allowed range is 1
to 31744 seconds; default query interval is 125 seconds.
QRI:
53
LANCOM GS-2310P/GS-2326(P) User Manual
3 Configuration
