Kyocera Mita DC-1560, Service Manual

Page: 276 / 289

1AF
3-6-38
Clean with isopropyl alco-
hol.
See page 3-6-32.
Clean with isopropyl alco-
hol.
See page 3-6-32.
Remedy if deformed.
Remedy or replace if de-
formed.
Reinstall the scanner wires
(see page 3-3-23).
See page 3-6-30.
Remedy if deformed.
Change the paper.
Change the paper.
Remedy if deformed.
Remedy if deformed.
Clean or replace the press
roller (see page 3-3-62).
Clean or replace the press
roller separation claws
(see page 3-3-62).
Clean or replace the heat
roller separation claws
(see page 3-3-64).
(1)
No primary
paper feed.
(2)
No secondary
paper feed.
(3)
Skewed pa-
per feed.
(4)
The scanner
does not
travel.
(5)
Multiple
sheets of pa-
per are fed at
one time.
(6)
Paper jams.
Check if the surfaces of paper feed
pulleys A & B and the bypass upper
pulley are dirty with paper powder.
Electrical problem with the paper
feed or bypass solenoid.
Check if the surfaces of the upper &
lower registration rollers and upper
& lower pre-transfer rollers are dirty
with paper powder.
Electrical problem with the registra-
tion solenoid.
Check if the front claws inside the
paper drawer are deformed.
Check if the springs inside the paper
drawer are deformed.
Check if the scanner wires are
loose.
Electrical problem with the scanner
motor.
Check if the front claws inside the
paper drawer are deformed.
Check if the paper is curled.
Check if the paper is excessively
curled.
Check if the front claws inside the
paper drawer are deformed.
Check if the springs in the paper
drawer are deformed.
Check if the press roller is extremely
dirty or deformed.
Check if the press roller separation
claws are extremely dirty or de-
formed.
Check if the heat roller separation
claws are extremely dirty or de-
formed.
3-6-5 Mechanical problems
Problem Causes/check procedures Corrective measures