Kyocera Mita DC-1560, Service Manual

Page: 180 / 289

1AF
3-3-24
(4-2) Installing the scanner wires
Required installation jig
• Scanner wire drum clips (P/N 34968130)
Procedure
The procedure is similar for both front and rear wires. The fitting of the rear wire is described
here. Numbers in circles correspond with those in Figures 3-3-28 to 3-3-30.
1. Remove the contact glass and left cover.
2. Holding the scanner wire with the spring on the right side of the machine and the round
terminal on the left, insert the ball into the hole in the scanner wire drum. .............
1
3. Run the end with the spring of the scanner wire three times around the drum toward the
machine inside. .......................................................................................................
2
4. Run the other end of the wire with the round terminal three and a half times around the
drum toward the machine outside. .........................................................................
3
5. Hold the scanner wire in place with the scanner wire drum clip. ............................
4
Ball
Scanner wire drum clip
Scanner wire drum
3.5 turns
3 turns
Figure 3-3-28 Winding a scanner wire