Kyocera Mita DC-1560, Service Manual

Page: 170 / 289

1AF
3-3-14
(8-2) Adjusting the leading edge margin
Adjust the leading edge margin as follows if it is not within the specified range.
Important : Before starting this adjustment, ensure (8-1) Adjusting the leading edge
registration timing has been completed.
Procedure
Start
End
Enter simulation mode.
Enter 54 with the numeric keys.
Yes
Yes
No
No
Press the print key.
Press the all clear/reset key.
Press the stop/clear key.
Press the print key to make
a test copy.
Exit simulation mode.
Is leading edge
margin A within the speci-
fied range*
1
?
Change the setting with the
zoom-up/down keys.
Press the print key.
Setting range: 1 to 200
References: 75 for 100% copy
100 for enlargement copy
30 for reduction copy
Increasing the value makes the margin wider,
and decreasing it makes the margin narrower.
*1 Specified ranges
3
±
2.5 mm for 100% copy
4.5
±
2.5 mm for enlargement copy
3
±
2.5 mm for reduction copy
The new setting is stored.
Select the mode to be adjusted
with the paper select key.
Mode 1: 100% copy
Mode 2: enlargement copy
Mode 3: reduction copy
Place an A3/11"
×
17" sheet on
the contact glass with the original
holder open (Figure 3-3-17).
Adjust for another mode?
A3/11"
×
17"
copy paper
Contact glass
A = 3
±
2.5 mm
Use a scale to measure accurately.
Figure 3-3-17