KUHN AXIS 20.1, Operator'S Manual

Page: 142 / 216

Spreading Operation B
130
AXIS-GENERAL
AXIS
20.1
AXIS
30.1 (W), AXIS 40.1 (W)
14. Check that there is a clearance between the spreading vanes and the outlet
by turning the spreading discs manually.
15. Fasten the calibration test chute and adjustment lever to their normal posi-
tions on the solid fertiliser broadcaster.
16. Reset the drop point to the determined spreading position.
B.7 Check mounting height
B.8 Setting the PTO speed
NOTICE
The cap nuts have an internal catching mechanism that prevents them from
coming loose. The stop must be felt when tightening the nut. Otherwise the cap
nut is worn and must be replaced.
NOTICE
Check with full hopper whether the preset mounting height is correct.

Take the mounting height setting values from the calibration chart.

The preset mounting height should not exceed the maximum allowed
mounting height.

See also „Preset the mounting height“ on page 46 .
NOTICE
Take the correct PTO speed from the calibration chart.