KUHN AXIS 20.1, Operator'S Manual

Page: 62 / 216

Standard operating procedure (all models) 8
50
AXIS-GENERAL
Setting the mounting height during late fertilisation
Requirements:

The solid fertiliser broadcaster should be connected to the tractor at the high-
est coupling point of the upper steering arm.

The lower arm of the tractor should be connected to the upper coupling
point of the lower steering arm of the solid fertiliser broadcaster.
Proceed as follows when determining the hopper mounting height (during late fer-
tilisation ):
1. Determine the hopper mounting heights A and B (above crop) from the cali-
bration chart.
2. Compare the hopper heights A and B (plus the crop height) with the maxi-
mum approved hopper mounting heights at the front (V) and rear (H).
Figure 8.10: Mounting position and height during late fertilisation
The following applies:
AXIS 20.1
AXIS 30.1/AXIS 40.1 AXIS 50.1 W
A + crop height
≤
V Max. 950 mm Max. 900 mm
B + crop height
≤
H Max. 1010 mm Max. 960 mm