Spreading operation
157
B
AXIS
20.1
AXIS
20.1
AXIS
30.1 (W), AXIS 40.1 (W)
AXIS 50.1 W
4.
Start the tractor. Set the PTO speed as specified in the calibration charts.
5.
Carry out further steps of action according to the electronic control system op-
erating manual.
6.
End calibration test. Disengage PTO shaft and switch off tractor engine and
lock to prevent unauthorised starting.
7.
Mount the spreading discs. Make sure that the left and right spreading discs
are not reversed.
n
WARNING
Risk of injury from rotating machine components
Contact with rotating machine components (universal drive shaft,
hubs) may cause bruises, abrasions and crushing injuries. Body
parts or objects may be caught and pulled in.
When the machine is running keep clear of the rotating
hubs.
If the drive shaft is rotating,
always
engage the metering
slide from the tractor cab only.
Direct all persons out of the danger zone of the solid ferti-
liser broadcaster before the calibration test
3.
Place the collecting contain-
er under the left outlet.
Figure 10:
Running calibration test
NOTICE
The pins on the spreading disc holders have different positions on the left and
right. The correct spreading disc is the one that fits precisely into the spreading
disc holder.
Summary of Contents for AXIS 20.1
