KUHN AXIS 20.1, Operator'S Manual

Page: 154 / 216

Maintenance and repair C
142
AXIS-GENERAL
AXIS
20.1
AXIS
30.1 (W), AXIS 40.1 (W)
C.5 Fertiliser drop point adjustment
Changing the drop point sets the working width and adjusts it for various types of
fertilisers.
Check the setting of the drop point at the start of each season and also during the
season if uneven spreading is noticed.
The fertiliser drop point is set on the upper scale plate.
Figure 22: Check the fertiliser drop point
Check:
1. Set the fertiliser drop on point to position 6 .
2. Remove both outlets together with their brushes at both openings.
3. Release both plastic levers (agitator drive) and slide downwards until the
splines of the agitator are showing.
4. Run a thin piece of string around the rear (on the side away from the tractor)
on the splines of both agitator shafts and tie off so that it remains tight.
 The triangular mark on the base plate must be aligned to the string.
 If this is not the case then the drop point must be readjusted.
NOTICE
The fertiliser drop on point must be set to the same position on both sides of the
machine. Always check both sides.